Table of Contents






sudo apt-get install hdparm
sudo hdparm -t -T /dev/hda # [[AmiloA]]
# Timing cached reads:   388 MB in  2.08 seconds = 186.89 MB/sec
# Timing buffered disk reads:   58 MB in  3.04 seconds =  19.10 MB/sec
sudo hdparm -gi /dev/hda # [[AmiloA]]
geometry     = 38760/16/63, sectors = 39070080, start = 0
Model=TOSHIBA MK2018GAS, FwRev=Q2.02 A, SerialNo=32963395A
Config={ Fixed }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=46
BuffType=unknown, BuffSize=0kB, MaxMultSect=16, MultSect=off
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=39070080
IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes:  pio0 pio1 pio2 pio3 pio4
DMA modes:  sdma0 sdma1 sdma2 mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5
AdvancedPM=yes: unknown setting WriteCache=enabled
Drive conforms to: Unspecified:  ATA/ATAPI-1 ATA/ATAPI-2 ATA/ATAPI-3 ATA/ATAPI-4 ATA/ATAPI-5
  • signifies the current active mode

And for SCSI ?



harddisk.txt · Last modified: 2017/07/11 18:04 by rzr
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki