sudo modprobe -v rt73usb insmod /lib/modules/3.4-trunk-amd64/kernel/lib/crc-itu-t.ko insmod /lib/modules/3.4-trunk-amd64/kernel/drivers/net/wireless/rt2x00/rt2x00lib.ko insmod /lib/modules/3.4-trunk-amd64/kernel/drivers/net/wireless/rt2x00/rt2x00usb.ko insmod /lib/modules/3.4-trunk-amd64/kernel/drivers/net/wireless/rt2x00/rt73usb.ko iwconfig [59273.423395] Registered led device: rt73usb-phy2::radio [59273.423483] Registered led device: rt73usb-phy2::assoc [59273.423600] Registered led device: rt73usb-phy2::quality [59273.426448] usbcore: registered new interface driver rt73usb [59273.441627] netlink: 140 bytes leftover after parsing attributes.
[ 206.812154] usb 1-2: reset full-speed USB device number 2 using ohci_hcd [ 207.350137] cfg80211: Updating information on frequency 2412 MHz for a 20 MHz width channel with regulatory rule: [ 207.350152] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350161] cfg80211: Updating information on frequency 2417 MHz for a 20 MHz width channel with regulatory rule: [ 207.350168] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350175] cfg80211: Updating information on frequency 2422 MHz for a 20 MHz width channel with regulatory rule: [ 207.350182] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350189] cfg80211: Updating information on frequency 2427 MHz for a 20 MHz width channel with regulatory rule: [ 207.350196] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350202] cfg80211: Updating information on frequency 2432 MHz for a 20 MHz width channel with regulatory rule: [ 207.350210] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350216] cfg80211: Updating information on frequency 2437 MHz for a 20 MHz width channel with regulatory rule: [ 207.350223] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350230] cfg80211: Updating information on frequency 2442 MHz for a 20 MHz width channel with regulatory rule: [ 207.350237] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350244] cfg80211: Updating information on frequency 2447 MHz for a 20 MHz width channel with regulatory rule: [ 207.350251] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350257] cfg80211: Updating information on frequency 2452 MHz for a 20 MHz width channel with regulatory rule: [ 207.350265] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350271] cfg80211: Updating information on frequency 2457 MHz for a 20 MHz width channel with regulatory rule: [ 207.350279] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350285] cfg80211: Updating information on frequency 2462 MHz for a 20 MHz width channel with regulatory rule: [ 207.350292] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 207.350299] cfg80211: Updating information on frequency 2467 MHz for a 20 MHz width channel with regulatory rule: [ 207.350306] cfg80211: 2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 207.350313] cfg80211: Updating information on frequency 2472 MHz for a 20 MHz width channel with regulatory rule: [ 207.350320] cfg80211: 2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 207.350327] cfg80211: Updating information on frequency 2484 MHz for a 20 MHz width channel with regulatory rule: [ 207.350334] cfg80211: 2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 207.354067] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' [ 207.358089] Registered led device: rt73usb-phy0::radio [ 207.358187] Registered led device: rt73usb-phy0::assoc [ 207.358264] Registered led device: rt73usb-phy0::quality [ 207.363077] usbcore: registered new interface driver rt73usb [ 207.461498] phy0 -> rt2x00lib_request_firmware: Error - Failed to request Firmware.
apt-cache search ralink
aptitude show firmware-ralink
aptitude install firmware-ralink
fcc id=k75-f5d7050b
windows 8 “no connections are available”