AKZ 430
ERROR
Update: I solved this issue by paying about 39EUR to have it reflashed (using eSAM module)
<iframe width="560" height="315" src="https://www.youtube.com/embed/-ETeSY686P0" frameborder="0" allow="accelerometer; autoplay=true; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>
Specs:
HARDWARE
Board:
EEPROM 24C
Control Panel
Temperature Sensor
Top Motor: PLASET P/N 74174 -10382- TYPE 72630
Element / Resistor
Bottom part: Observed 40 OHm , unsure about the reference
interupteurs thermiques
Turn off supply (20 sec or more?)
set knobs to 12 oclock
Power on
Press and hold Select button 5 secs (quickly after poweron)
Press Select button 4 times
Press Select button 5 secs and release
Press 5 secs
Turn left knob to different tests
+1cw (lamp) : “1 P5”
+2cw (?cp) : 88:88 beep
+3cw () : “3 32”
+4cw (fan) : “4 00”
+5cw () : “5 00” , plus fan noise
+6cw (?motor): “on” (or “off”)
+7cw (?CLn): “F 03”
-
Select OFF and set to ON (5 secs press like before)
Rotate clock wise to off position
Links:
ERROR : F03
Observe:
ToDo :
Reprogrammer l'EEPROM en utilisant SAM.
Si le problème persiste, changer la platine Antares
Misc:
Service:
Parts :
Service:
MisC:
MISC:
Notes
Whirlpool
misc
<iframe width="560" height="315" src="https://www.youtube.com/embed/dsepPhPKQk0" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe>